Hearts
- Thread starter workinforwood
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
Seer
Member
Looks great Jeff nice work.
johncrane
Member
Very nice Jeff should win a heart or two with them:biggrin:.
johnnycnc
Member
Nice work Jeff, the outlines look very clean.
Ligget
Member
Cool pens, the hearts look fantastic!
Yep, they both are very cool:biggrin:
Did you scroll the hearts? The edges look VERY smooth, so I'd be very impressed if you did.
Did you scroll the hearts? The edges look VERY smooth, so I'd be very impressed if you did.
Flash back to the good old days. Nice stuff.
workinforwood
Member
yes, you scroll the hearts. they are acrylic, same as the rest of the blank and the heart only goes half way through. You cut out the heart, trace it on the blank. Cut the blade in half and install into the upper arm of the saw only. Install a super magnet in the bottom to hold the blade straight. Drill a starter hole, then cut with blade halfway down into blank staying inside the line, then come back with a chisel and notch out the area and glue in the heart.
The edges of the hearts, sure they are pretty smooth. Not as perfect flowing as a laser would do, but the seam is as good if not better than a laser. Typically, this is what people want. Small and simple.
:biggrin::biggrin: Nutter!!! Wasn't there a BS contest sometime ago? You'd win with that one for sure!!!
workinforwood
Member
HEHE...yea, maybe the operation isn't quite that complicated. I did scroll it and it is only on one side of course. :wink:
Dan26
Member
Very cool!
Mrs Rojo22
Member
Nice!
Robin
Robin
broitblat
Member
Nicely done!
What did you use to "cut" the blade with
-Barry
What did you use to "cut" the blade with
-Barry
bitshird
Member
Jeff you're getting pretty good with that alumilite, Nice pens as usual!!
Dalecamino
Local Chapter Leader
Great work Jeff .