Got a question about Wall Street II click

[tommy2tone]

I was going to make a WS II click. Turned the blank but later found out it was too small. I had already assembled the top click part in to the blank. When I put it together the refill stuck out to far. Needless to say I destroyed the click part trying to disassemble so I could use the blank on a regular Wall Street II. Is there amyway to get another "click" part?

 

[BayouPenturner]

I did the same mistake and had to purchase another pen. Caution when making click pens they are critical for measurements.

 

[toddlajoie]

There were also a few different versions of the Sierra/WallStII/etc clicks where some used much shorter tubes than the twist versions, while others, newer ones I think) use tubes that are just slightly shorter than the twists...

I know at one of the local store, their bins for those pens have a mixed collection of both, and I think a few of our online friends sell both, but have them clearly identified if they are the older or newer style...