OSCAR15
Member
I had purchased a 60 deg live center from Little Machine Shop, and had been using with no problems at all for several months. Now, when I engage tailstock, and turn lathe on, it seems that either the live center isn't moving, or sometimes it turns Very Slowly....
When lathe isn't in use, it spins freely, so I do not think it is a bad bearing in the live center.... I do not overtighten tailstock, or nut on mandrell.
The sound is somewhat a chatter, but extremely loud......
Has anyone else run across this
I would appreciate any advice...
Thanks in advance....OSCAR
When lathe isn't in use, it spins freely, so I do not think it is a bad bearing in the live center.... I do not overtighten tailstock, or nut on mandrell.
The sound is somewhat a chatter, but extremely loud......
Has anyone else run across this
I would appreciate any advice...
Thanks in advance....OSCAR