Gregf
Member
Just received a couple of Toni's polymer clay blanks. Thinking of using GluBoost as the finish. Has anyone used GluBoost on polymer clay, or know if there could be an issue ?
TIA,
Greg
TIA,
Greg
GluBoost over polymer clay.
- Thread starter Gregf
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
its_virgil
Member
Gregf
Member
I did, she has never used it.
its_virgil
Member
She uses BSI CA glue if I recall. I have used both Hot Stuff and Mercury on several of Toni's blanks. But, that doesn't answer your glue boost question.
Don
Gregf
Member
BSI is what she uses. Her instructions say not to use Stickfast. Didn't ask why.
mg_dreyer
Member
I have used GluBoost on polymer clay pens on numerous occasions. No problem at all. It is my go to finish.
Gregf
Member
Thx! Couldn't see why it wouldn't be ok, but didn't want to chance a $50 blank.
mg_dreyer
Member
If you have any concerns just start with the orange (fill n finish - thin). Just use a few more coats. Very light steel wool in between. Very light, lathe off bushing to bushing.
jttheclockman
Member
That story goes way back when there were CA wars were here. I believe BSI is a flexible CA and has different properties than other CA glues. Definitely not the same as Gluboost.
Gregf
Member
Makes sense given the properties of polymer clay that a flexible CA would be best.