WriteON
Member
Would like to buy a kit. I need suggestions for a start up system. The 2272 looks like it has everything I need. I'll take suggestions or comments. Want to buy right the first time. Thank you.
I have a Master Carver Set Up with the three handpieces as listed in this pic. The geared hand piece will open to 1/4". The smaller handpiece is lighter and easier for smaller bits and smaller hands. The reciprocating handpiece is cool too.
This is also 1/2 HP....plenty of power. I would suggest ordering a couple of replacement shaft cores in case you snap one.
I am very pleased with this unit....have the foot pedal control.....will probably get the table top speed controller too for steady consistent speed.
I also made a fixed bracket to mount the motor so it wouldn't rotate as it does with the hanging bail loop and support.