Justturnin
Member
I am selling my old Speedy Sprayer pressure pot. I upgraded to a Binks a while back and thought I would use this one too but I never do. I am now wanting a larger pot than the Binks so I am getting rid of this one to go towards it.
It's a great pot and is 100% ready to cast. I have it set up for Pressure or Vaccum but the vacuum is an Auto fitting not an Industrial but can be swapped out for a few bucks. It has 2 valves, one between the pot and gauge in case you use it for vacuum and one one the outside of the gauge to monitor pressure. The max PSI on this pot is 50psi and it means it. If you go over the gasket will roll out and release but I have never had an issue when I used it at 45psi. On top of that it comes with the rack that I built for it. The racks not sexy but it works.
To ship I would prefer to remove the stem with the valves and gauge to make sure it does not break. Chances are FedEx is going to be the best rate for this so if you would like it claim and give me your Zip code so I can figure out the exact shipping.
Asking $150.
It's a great pot and is 100% ready to cast. I have it set up for Pressure or Vaccum but the vacuum is an Auto fitting not an Industrial but can be swapped out for a few bucks. It has 2 valves, one between the pot and gauge in case you use it for vacuum and one one the outside of the gauge to monitor pressure. The max PSI on this pot is 50psi and it means it. If you go over the gasket will roll out and release but I have never had an issue when I used it at 45psi. On top of that it comes with the rack that I built for it. The racks not sexy but it works.
To ship I would prefer to remove the stem with the valves and gauge to make sure it does not break. Chances are FedEx is going to be the best rate for this so if you would like it claim and give me your Zip code so I can figure out the exact shipping.
Asking $150.