First use of Aluminum

Signed-In Members Don't See This Ad
See more from fiferb

Status
Not open for further replies.
fiferb

fiferb

Member
Joined
Mar 20, 2006
Messages
2,440
Location
Ninety Six, SC, USA.
This is a Polaris Pencil in Walnut. I cut at 5,10,20,30 and 40 degrees. The sandwich is maple between two slices of aluminum can. Finish is CA/BLO. There are a couple of errors but I'll wait and see if you point them out. Any and all comments or critques greatly appreciated.

2007613123735_Walnutaluminummaple.jpg
 
Signed-In Members Don't See This Ad
nice job, I like the look of it. Not really a fan of of the kit though.

wild guesses on your errors:
spacing between segments
lining up grain between segments
 
Bruce,
That's a pretty darn good job you put forth there! I don't see any errors except maybe the sections aren't spaced evenly apart? It might even be more dramatic if they were closer together. I've made one pen similar (my sections were all 90 degrees). I think I used gutter flashing in mine.
[8D]
 
Status
Not open for further replies.
Back
Top Bottom