Haynie
Member
Holy cow when people said it would dull the tools quick they were not kidding. I started with a scary sharp gouge and a scary shark skew. They were both dull as butter knives before the blank was half rounded. I am using Azurite web. A super sharp drill bit helps too, or the bits from PSI just suck. I was drilling and all of a sudden a quarter inch chip broke off the bottom. Lucky I bought 2 blanks. I ended up turning the blanks on the metal lather with the carbide tools.
On another note always make sure both pages or sides to the instructions are in the package for the Majestic Jr. kits, or caliper the bushings. I was only supplied with the first page so missed the fact that one cap bushing was bigger than the other and over turned. Oh well this was for me any way, a practice before tackling the christmas presents.
Lots of learning today.
Oh Yeah Under Armor is your best friend in a cold shop.
On another note always make sure both pages or sides to the instructions are in the package for the Majestic Jr. kits, or caliper the bushings. I was only supplied with the first page so missed the fact that one cap bushing was bigger than the other and over turned. Oh well this was for me any way, a practice before tackling the christmas presents.
Lots of learning today.
Oh Yeah Under Armor is your best friend in a cold shop.