candy1land
Member
I finally got to use my new Delta VS Lathe this weekend to turn my first pen unsupervised! (My very first pen I turned in my WoodCraft class two weeks ago).
I had a lot of "learning" moments with the tools I was trying to use and I was actually try to make two of these - one pencil and one pen - but the other blank ripped in half while I was using the barrel trimmer.
So in the end this is what I got...not bad for my first try with no help! Any tips, comments, suggestions are welcome.
I didn't do as good of a job on the transitions as my first go around but at least I know the bushings are true to the pen kit.
Candy
I had a lot of "learning" moments with the tools I was trying to use and I was actually try to make two of these - one pencil and one pen - but the other blank ripped in half while I was using the barrel trimmer.
So in the end this is what I got...not bad for my first try with no help! Any tips, comments, suggestions are welcome.
I didn't do as good of a job on the transitions as my first go around but at least I know the bushings are true to the pen kit.
Candy