First fountain pen!

[furini]

Hi all

Still a newbie here but managed to make my first fountain pen yesterday - did manage to destroy a coolibah burl and laceoak blank until I got it right third time lucky - still, here it is:

Made from olive wood - the last nice blank I had. The kit is an Americana from The Turners Workshop. I've managed to get a few scratches on the brass where the pen is held but for £3.45 it's a good one to learn on.

Had a problem with the bushings in that the centre bushing didn't fit inside the pen tube - it seemed to be the same diameter as the tube instead...anyone any experience of this? Is the bushing wrong??

Thanks all

Stewart

 

[nava1uni]

You might of had some glue in the tube. I use a brass brush to clean the tube. In my experience it only takes a little bit of glue to make the bushings not fit properly.

 

[furini]

Hi Cindy
thanks for the tip - I tried the bushings before the tube was glued in but it didn't fit then either. However, I certainly had glue in in later as the tubes ended up being in three blanks until I got it right!