rjwolfe3
Member
Just ordered this: PSI Woodworking CSC500K Barracuda Micro Key Lathe Chuck System for $115 (free shipping) from Amazon. Comes with 3 sets of jaws.
Can anyone tell me if this was a good deal or did I jump the gun? I was looking at a cheaper ($45) 4 jaw chuck from Grizzly thru Amazon but wasn't sure if it would do what I needed it to do.
I basically wanted to start drilling on the lathe and turning round on the lathe and making small bowls as well as other small stuff.
Does anyone have this chuck that can give me the pros and cons of it? As well as any tips for using it correctly and safely?
Thanks for looking.
Can anyone tell me if this was a good deal or did I jump the gun? I was looking at a cheaper ($45) 4 jaw chuck from Grizzly thru Amazon but wasn't sure if it would do what I needed it to do.
I basically wanted to start drilling on the lathe and turning round on the lathe and making small bowls as well as other small stuff.
Does anyone have this chuck that can give me the pros and cons of it? As well as any tips for using it correctly and safely?
Thanks for looking.