jakoop
Member
So, the green stabilized buckeye burl I had had 2 "holes" in it. One I could see before I began turning and I thought it might go away as I turned the blank down. The other appeared after I started turning. Now I am new to all this but I think I remember reading about putting the turning dust in the hole, which I did. Then I put Thick CA glue on it. It didn't hold very well. So then I tried again using thin CA glue and it seemed to hold better. The top picture, part of the hole went all the was to the brass. Not sure why it is black? Is there a different way to fix these holes? I still like the way it turned out, and my daughter will love it for her Christmas gift.
Thanks for any advice and Happy Thanksgiving
Thanks for any advice and Happy Thanksgiving