Muggsy1776
Member
Has anyone engraved the metal band between the clip and the finial on a Jr pen?
Engraving Jr cap
- Thread starter Muggsy1776
- Start date
Signed-In Members Don't See This Ad
gimpy
Member
I have not, but sure it can be done
Muggsy1776
Member
A jeweler would likely be able to engrave it. I just wondered how the finish would handle it. Is it a thin finish that could flake off around the cuts.
Penultimate
Member
You might be able to laser it. If you engrave to deep you will hit the brass substrate.