NC Wood Art
Member
I just had to redo the finish & sanding on one of my Redwood lace blanks I was turning because of dirty micro mesh, I had just turned an Ebony letter opener & polished it with the micro mesh The right behind it was turning a Redwood lace Rollerball, the blank is 2 tone with some sapwood showing & the micro mesh turned the lighter end almost Grey with the contaminants from the Ebony blank. I know I can hopefully sand it out with clean sandpaper & try again but is there anything to use to clean the micro mesh or just rinse it off with clean water? They are only $14.00 for new set but they are not that old only turned a few pieces with them. Maybe I need a set for similar woods?
Bill
Bill