texasfootball21
Member
So I was cutting and drilling antler today in the shop. I cut a piece of whitetail for a Jr. Gent and drilled a hold for the pen body using a 10.5 mm bit. The hole is horrible! It is much to large at one end and I suppose the bit was very unsteady while I was boring. The drill bit I use is a terrible tabletop Ryobi.
The problem is that this antler is being used in a commissioned order with the clients antler and I have very little left.
Is there a way to salvage the pen? I mean the CA glue may not hold the tube in the hole.
Thanks.
The problem is that this antler is being used in a commissioned order with the clients antler and I have very little left.
Is there a way to salvage the pen? I mean the CA glue may not hold the tube in the hole.
Thanks.