Dewalt Drill Bit Set, 29 PC DW1969 | Zoro.com
These are my favorite bit for sheet metal, (believe it or not), they make nice round holes. I have not tried them in wood or plastic. I will have to locate some.
For making pool cues drilling the joint pin hole I normally can get 0.0015 run out .
One in a half thousands for a 3.250 deep hole is not bad for a three dollar and fifty cent Dewalt drill bit.
But I have noticed that I have to replace the bits every two or threes years because they start to walk.
I drill on using my lathe and to be very honest the big bore spindle 1.385 is so nice turning square wood to round wood with the 4 jaw chuck and a live cutter.
I don't use plastic very much, Cue ferrules and paper wrapped phenolic .
and normally never use acrylic.
My point is I don't know how the Dewalt drill bits will hold up drilling acrylic.
Drilling a blank on a drill press I would think a pen blank vise would be a must and the chance of bending a bit in acrylic would easy if the operator allow the bit and blank to get hot while drilling.
Actually acrylic is water proof and a person could use some kind of lube or water to cool the bit if that is a problem.
Are you in Reno ?