candy1land
Member
I am starting to do much more of the larger kits, Majestic, Statesman, Gent etc...
And I'm using drill bits I received from PSI in their starter packs. I am finding that they blow out the bottom of the blank in the pen vise while I'm drilling them and I'm not sure if it's because they are not quality drill bits or if I should just not drill all the way through and cut the end off with my bandsaw.
Are there higher quality larger drill bits out there I should consider or a different method I should use instead? I've looked at the Colt Drill bits but they don't make 10.5 and 12.5 which is what some of the larger kits are calling for?
Any suggestions would be appreciated.
Thanks,
Candy
And I'm using drill bits I received from PSI in their starter packs. I am finding that they blow out the bottom of the blank in the pen vise while I'm drilling them and I'm not sure if it's because they are not quality drill bits or if I should just not drill all the way through and cut the end off with my bandsaw.
Are there higher quality larger drill bits out there I should consider or a different method I should use instead? I've looked at the Colt Drill bits but they don't make 10.5 and 12.5 which is what some of the larger kits are calling for?
Any suggestions would be appreciated.
Thanks,
Candy