pmpartain
Member
This is an El Grande ballpoint. Walnut with some burl as a base, poplar cross, Enduro finish. I understand that you want the cross material to be the same thickness as your blade kerf. I cut on the table saw. Any suggestions on a thin kerf blade, so the cross material can be thinner? You can see that the finish was too thick to allow the top of the pen to fit properly. I mis-judged how much of the lower barrel would be covered, and you can see my mistake there. ARRRGGGGG! Oh well, looks like I get to keep one of my own!
Thanks very much.
Thanks very much.