Does anyone have a "clicker" pen kit?

[Texatdurango]

I am looking to buy some kits to rob the clips from and the clips on the Craft Supply Clicker pens http://www.woodturnerscatalog.com/s...rgs=&imgsrc=/products/large/clicker-pen_l.jpg look nice.

If anyone has any of these kits, would you mind measuring the total
length of the clip and the diameter of the ring itself, both inside and outside diameters?

Would appreciate the help as it will save me ordering some just to measure myself.

Thanks

 

[bruce119]

Using my mike. the length of the clip is 1.740 and the ring is .449 O.D. & .343 I.D.

Hope this helps. I got my Clicker from Lau Lau Woodworks but I think they are the same kit.

Bruce

 

[Texatdurango]

Thanks Bruce, those are the measurements I needed to hear, now to see if that will work for me, the OD sounds a little on the large side and after seeing the photos on the Lau Lau Woodworks site, I can see that the clip ring is designed to be seen.