diminsions needed

[nwcatman]

if anyone has the footprint size, including maybe the bolt hole spacings , for a nova DVR XP i would appreciate the infor. THANKS JOHN

 

[wdcav1952]

John,

This might help. Page 11 of the pdf shows plans for a stand so that should give you some idea.

http://www.teknatool.com/products/Lathes/DVR XP/Downloads/Nova_DVR_XP_manual_Jun_08.pdf

 

[nwcatman]

it didn't, but was a good idea anyway. thanks.

 

[holmqer]

if anyone has the footprint size, including maybe the bolt hole spacings , for a nova DVR XP i would appreciate the infor. THANKS JOHN

The base of the Nova DVR XP is 7 1/8" x 40 1/2"

The bolt holes are 1/2" in diameter, centered 3/4" in from the edge.

Measured from the tailstock end of the lathe, the centers of the bolt holes are offset 1", 7 1/4" and 33".

 

[nwcatman]

now that works! thanks john