Cincinnati
Member
How much clearance over the OD of the brass tube should be allowed when choosing a drill bit size?
Determining Correct Drill size
- Thread starter Cincinnati
- Start date
Signed-In Members Don't See This Ad
KenV
Member
I like about 0.005 to 0.010 clearance - most instructions exceed that substantially.
JerrySambrook
Member
it also depends on the material
Roughly .010 oversize, or the next size BELOW that.
If the gap is too small, you will start the glue line.
If the gap is too large, with most glues you will have too large a bridge.
If you are using epoxy, then you will lessen your problems.
Please do not depend on poly glues "gap-filling" expansion to give you a good glue line though
Roughly .010 oversize, or the next size BELOW that.
If the gap is too small, you will start the glue line.
If the gap is too large, with most glues you will have too large a bridge.
If you are using epoxy, then you will lessen your problems.
Please do not depend on poly glues "gap-filling" expansion to give you a good glue line though
whatever
I use my drill bit sizer...usually I find the first drill size the tube will not pass through and use the next size up drill bit (usually 1/64th bigger). Works for me