GABJR
Member
I just attempted my first designer pen. Everything looked good until the fit up of the kit. All the fits were loose. A little ca took care of the pieces except for the mechanism. The mechanism slid right in with hand pressure & became loose the further in it went.
The tubes look a little out of round. What could have caused this ?
Does anyone have any sugestions on salvaging this pen ?
Any thoughts on the cause of this & how to prevent this from happening again ?
The tubes look a little out of round. What could have caused this ?
Does anyone have any sugestions on salvaging this pen ?
Any thoughts on the cause of this & how to prevent this from happening again ?