lyonsacc
Member
I have inherited a new (to me) table saw, so I need to clear out some space in the basement. This is a Delta 10 inch table saw that I bought back in the mid-90's. Runs well (no problems). The fence is pretty good (I haven't fined tuned it in years). At some point about 18 years ago we had a leak in the room above the shop, so there was some rust on the table top - it has been dealt with, but the rust left it's mark - the table top is not pitted or anything, just blemished (looks a lot worse in the picture than it is). Comes with the blade in the pic. Also, have the blade guard (not in the pic). Will through in a stack dado blade and dado blade insert. One of the knobs (to tighten down the angle of the blade) is hiding somewhere in the basement, so I have made one to take its place. Must pick up (the boys and I will get it into the garage for you). $150 firm.
Thanks!