I like it but I wish there was a little more of that silver luster in the lower barrel so it would match up a little more. Just one tip (just incase it's news) is to always drill your holes from the joining faces when you cut the blank. Also, if your blanks are too long and you have to mill them down, make sure you seat the tubes as close to that cut edge as possible on both blanks. That way you mill away from the far ends of both blanks the majority of the material. This leaves the transition from one blank to the next very smooth because hardly any material between them was removed.
Again, I don't know if you know that or not, just wanted to mention it.
Are you using MicroMesh or a buffing wheel?