JayDevin
Member
Hello all, Need some advice.
I recently bought some of the Exec Rollerball pens from Craft Supply, The first set of bushings would not go on my 7mm mandrel
too small, Called CS and they sent out another set.......same thing too small....they appear to be 6mm not 7mm....so I have 2 kits all glued and drilled and ready to turn and now have 2 sets of bushings that wont fit. SHould I go to the trouble of trying to drill out the bushings? Try and turn with calipers only? I have 2 very pretty acrylic blanks that are now committed to this kit. I could call CS again but a third set of non fittung blanks is not the solution. I also have 2 more of this kit that is useless with out bushings.....arrrrrgh! Jay
I recently bought some of the Exec Rollerball pens from Craft Supply, The first set of bushings would not go on my 7mm mandrel
too small, Called CS and they sent out another set.......same thing too small....they appear to be 6mm not 7mm....so I have 2 kits all glued and drilled and ready to turn and now have 2 sets of bushings that wont fit. SHould I go to the trouble of trying to drill out the bushings? Try and turn with calipers only? I have 2 very pretty acrylic blanks that are now committed to this kit. I could call CS again but a third set of non fittung blanks is not the solution. I also have 2 more of this kit that is useless with out bushings.....arrrrrgh! Jay