I use decal paper from
Inkjet Decal Paper
I use inkjet since that is the only color printer I have.
I make my logo using paint.net (you will have to figure out the size depending on the pen)
I mainly use clear decal paper and a light color blank since white isn't a ink color.
i usually let it sit a day and dry after printing.
Then I spray it with Testors Decal Bonder spray( i never could get lacquer to seal the ink) 2 med. coats at least a hr a part. then let it sit over night.
Then cut the decal out then apply it.(about 20 -25 sec. in water) smooth it out and let it sit over night and dry.
Apply Ca glue,
first coat I apply using what ever paper towels my wife buys. I apply it to paper towel then wipe it over decal and around the blank. (lathe off)
then at a slow speed i apply 2-6 coats ca(i put a med coats on)
Wet sand it 400 grit
then i go thru the Micro Mesh grits
Then I buff it out using a homemade buffing set up using Tripoli then White Diamond