Woodnknots
Member
All,
I have not participated in this forum in quite some time, but was quite active when I did, and enjoyed the conversation, the advice, and the look at some quite stunning work that I tried at times to emulate to the best of my ability. This addiction has always been a stress relief for me, but due to some unfortunate circumstances, I needed to make a decision between selling my turning equipment or the rest of my shop. Quite honestly with my clientele, my earning potential is better with flat work, so...
I am in Carrollton, VA, if anyone would like to stop in and see what I have. I have at least $4k worth of stuff collected over the years (new retail, not used, obviously). I am pasting my CL add to make it easier.
Thank you all for all the advice, support, and the fun conversation over the years.
Dave
Full size wood lathe complete start-up
I have not participated in this forum in quite some time, but was quite active when I did, and enjoyed the conversation, the advice, and the look at some quite stunning work that I tried at times to emulate to the best of my ability. This addiction has always been a stress relief for me, but due to some unfortunate circumstances, I needed to make a decision between selling my turning equipment or the rest of my shop. Quite honestly with my clientele, my earning potential is better with flat work, so...
I am in Carrollton, VA, if anyone would like to stop in and see what I have. I have at least $4k worth of stuff collected over the years (new retail, not used, obviously). I am pasting my CL add to make it easier.
Thank you all for all the advice, support, and the fun conversation over the years.
Dave
Full size wood lathe complete start-up