StanBrown
Member
I was assembling a Comfort Pen kit today. I had the rubber gripper on the exposed length of tube, all good so far. I was about to press the tip into the end of the tube when I noticed it just slipped into place with no pressing necessary. It was not really loose, just did not fit tight enough to stay in place. The tube did not appear to be distorted or enlarged (to the naked eye). I did not want to waste the work and materials so I put a very tiny drop of CA on the insertion portion of the tip and then pressed it in place by hand. It seems to be holding so far.
I was wondering if anyone else has had this problem? If so, what was your solution? If not, what do you think I did wrong?
Thanks in advance for comments and suggestions.
I was wondering if anyone else has had this problem? If so, what was your solution? If not, what do you think I did wrong?
Thanks in advance for comments and suggestions.