DKF
Member
What size collet are you guys using for the "B" mandrel rod? My 1/4" seems too small, and the 3/8" is too large...is it a <s>3/16</s>", 5/16", which of course I don't have? Thanks.
Collet size for a "B" mandrel rod?
- Thread starter DKF
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
jimbo5576
Member
Use a 5/16's
jimbo5576
Member
5/16" that is
wdcav1952
Activities Manager Emeritus
Just to be different, what about a 10/32? [}
]
]
jcollazo
Member
It is 5/16". That's the one I use to make the B mandrel rods.
DKF
Member
Thanks guys.....that's it....what a bonehead I am....I guess I meant 5/16"...other than Beall, suggestion as to where to pick one up?
loglugger
Member
Don't know if it is the best price but www.use-enco.com has them.
Bob
Bob
Monty
Group Buy Coordinator
Don't see any listed now but I've picked up extras off eBay.
jcollazo
Member
I'm hoping to have more in stock by the weekend. $9.00 each.
BigShed
Member
Usually quite a few suppliers on Ebay, also littlemachineshop.com has all that stuff.
BigShed
Member
Joe, do you ship to Australia?
What size are these collets, ER32?
Can you supply collet chucks as well?
jcollazo
Member
I ship anywhere. These are the ER32 collets (Beall and PSI chucks). Unfortunately I don't carry chucks.
I got an email from my supplier this evening stating that they hope to ship within the next two days. That'll put my delivery date into the middle of next week.
I got an email from my supplier this evening stating that they hope to ship within the next two days. That'll put my delivery date into the middle of next week.
DKF
Member
PM Sent
loglugger
Member
Sorry Joe I forgot that you had them.
Bob
Bob