It is really pretty easy.I just use med. CA
There is a step by step process one needs to take.
1.cut 2 blanks the same size 2.smooth sides up, do NOT sand
3. use denatured alcohol and a paper towel to clean all the lint off of the blanks. the alcohol also acts as an accelerator so have several spring clamps ready
4.Wear gloves,place blanks on waxed paper, apply med. CA glue liberally
5.Quickly rub the sides together making sure all surfaces are covered
6.Place spring clamps covering the entire blanks and there you have it! About 5 clamps for a regular blank. they begin to bond fairly quickly
Just let it dry for a couple of hours or over night
cut to square up on the table saw.
In very busy patterns sometimes you can see where they are glued. This is because of patterns not matching.
If done right and with most patterns no seam shows.
Alice
Is that corian? If so, how did you bond it so it doesn't show a seam?