Charlie_W
Member
Today, I have a question.....(and yes, I did check the library reference chart)
While looking at the PSI catalog, I found circuit board blanks in 4 different tube sizes. Just cut to length as needed.
7mm, 8mm, 3/8", and 10mm.
I am thinking it is the 10mm as the Zen directions say to use a 10.5mm drill bit.
Can someone confirm which one will fit a CSUSA Artisan Zen...if any?
Thanks in advance
While looking at the PSI catalog, I found circuit board blanks in 4 different tube sizes. Just cut to length as needed.
7mm, 8mm, 3/8", and 10mm.
I am thinking it is the 10mm as the Zen directions say to use a 10.5mm drill bit.
Can someone confirm which one will fit a CSUSA Artisan Zen...if any?
Thanks in advance