Firefyter-emt
Member
Guys, I have made a few cigars now and I only seem to have one issue. It appears like the center end of the lower tube is a hair too big. If the part that pressed into the lower tube that accepts the transmission to thread on was not rounded it may fit perfect. My issue is not too much wood left, the blanks are perfect to the bushing, but if you look at it you can just see the edge of the wood. Now short of lightly rounding that edge of the blank prior the lacquer finish, what is wrong? Do I have a bad bushing that is a hair too thick? All the others are perfect, this one just seems a bit big. These are Berea pens & the proper Berea bushings (from BB)
You can just make it out in the closeup photo.
You can just make it out in the closeup photo.