leatherjunkie
Member
I went and took the plunge today. I decided to make my first churchhill pen.
I went down to the local woodcraft store and picked up all the materials. bushings, 33/64 (allready have 31/64) pen kit and some black walnut.
Just drilled out the wood blanks and the cap tube(33/64 bit) is way too tight. so i drilled a hole in some scrap wood with same bit and tube would not go in hole.
I checked aronzia sil's site to verfiy the drill size in case woodcraft listed the wrong drill bit size. the drill bit is in fact 33/64.
has anyone ran into this problem and what did you use to fix this problem?
thanks in advance for your help
I went down to the local woodcraft store and picked up all the materials. bushings, 33/64 (allready have 31/64) pen kit and some black walnut.
Just drilled out the wood blanks and the cap tube(33/64 bit) is way too tight. so i drilled a hole in some scrap wood with same bit and tube would not go in hole.
I checked aronzia sil's site to verfiy the drill size in case woodcraft listed the wrong drill bit size. the drill bit is in fact 33/64.
has anyone ran into this problem and what did you use to fix this problem?
thanks in advance for your help