amosfella
Member
I have a few question about casting. I had tried to use autobody PR as a casting resin, and use acrylic paint as a coloring agent. When I did that, the PR hadn't cured in 24 hours. I used 25 drops of MEPK in about a 5x5x7/8 mold sized pour. It wasn't curing, so I did the same thing again, adding more PR, and still using acrylic paint. The top half hardened, but the bottom stayed soft. On the 3rd try, I used 60 drops, and it hadn't hardened at all.
I'm doing this in a heated shop, that's about 68 degrees. Is the autobody PR not suitable for casting??
Where is a good place to buy Alumilite if that is recomended that will ship to Canada?
Has anyone tried epoxy casting resin, or acrylic resin??
Has anyone tried coating tubes with the clear epoxy finish used on bars and such high wear areas that you aparently can cast coins and such under??
Thanks for your answers in advance.
I'm doing this in a heated shop, that's about 68 degrees. Is the autobody PR not suitable for casting??
Where is a good place to buy Alumilite if that is recomended that will ship to Canada?
Has anyone tried epoxy casting resin, or acrylic resin??
Has anyone tried coating tubes with the clear epoxy finish used on bars and such high wear areas that you aparently can cast coins and such under??
Thanks for your answers in advance.