duncsuss
Member
Another rollerball dressed up in resin with Fordite chunks ... thanks for looking 
Cast Fordite on a rollerball #2
- Thread starter duncsuss
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
rherrell
Member
I never heard of the stuff until you posted, I like it!!!
duncsuss
Member
It's a tricky material to work with, has a tendency to delaminate when a cutting edge meets an edge. I found I get fewest disasters if I turn it using negative rake scrapers till the flats are gone then wet-sand the rest of the way.
Jim15
Member
Another beauty.
duncsuss
Member
Thanks Jim!
Dalecamino
Local Chapter Leader
That's even cooler than the first one Duncan! Nice!
duncsuss
Member
Thanks Chuck! I do too, but haven't quite figured out why. Do you think it's because there's more of the swirly resin visible?