One thing to think about when picking your glue is your process of applying the finish. I used to use stick fast and e-z bond but the process was to build up a thick layer, only to sand it off. That was a lot of wasted glue. Plus, if you used the accelerator there was a chance that you would find cracked in your finish down the road, because they weren't as flexible as the new stuff, like Gluboost, which was designed as a finish and not just a glue. The green and red are more for gluing while the orange and blue are for finishing. I used to spend 30-60 minutes applying a CA finish with minimal accelerator so it wouldn't crack later. The newer stuff does cost more but I can now apply a finish in 5 minutes with half the glue i used to use, allowing me to get more done in a short amount of time. To me that is a savings and worth a little higher price on the supply, but that's just my opinion with the process that works for me.