I'm wondering how many of you put a little dab of CA on the inside of your barrels before assembly.
I'm thinking that it would ensure a good bond between the hardware, especially where there's the tension of a spring against it all the time.
Then again, I'm thinking that it might be a waste of time. I buy most of my kits from Craft Supplies, and I think that their fit and finish on pens are pretty good.
Necessary or not?
I'm thinking that it would ensure a good bond between the hardware, especially where there's the tension of a spring against it all the time.
Then again, I'm thinking that it might be a waste of time. I buy most of my kits from Craft Supplies, and I think that their fit and finish on pens are pretty good.
Necessary or not?