jimr
Member
I have read a lot about this and gave it a try yesterday. End result was I really messed up a turned blank. Questions- what is the BLO for, I understand it is applied first followed immediately by the CA. What does it add to the process?
I tried applying the thick CA as the blank was turning and immediatley after applying the CA. I used bounty paper towels. I may have used to much CA but it seemed like I had to in order to get the entire blank length covered.
Is the CA supposed to cure as pressure is applied by the paper towel as it it moved back and forth? I wound up with sticky CA and later had to sand it off. If done properly will the CA cure and leave a smooth, glossy finish? I would like to try this again but I don't want a similar result. Advice would be appreciated.
I tried applying the thick CA as the blank was turning and immediatley after applying the CA. I used bounty paper towels. I may have used to much CA but it seemed like I had to in order to get the entire blank length covered.
Is the CA supposed to cure as pressure is applied by the paper towel as it it moved back and forth? I wound up with sticky CA and later had to sand it off. If done properly will the CA cure and leave a smooth, glossy finish? I would like to try this again but I don't want a similar result. Advice would be appreciated.