NotURMailman
Member
I had the best CA finish I had managed yet last night on a long tube click in Ziricote. Then I proceded to chip the ends when I tried to trim the excess before assembly. How frustrating!
I put it back between the bushings (delirn BTC bushings from PTP) and repaired it. But I can still see where it was repaired. I am so bummed. Everyone else says they can't tell, but I can.
What is everyone's most succesful method of getting rid of the excess CA before assembly?
No pics, I quit posting pics because I just get griped at about the photo quality...
I put it back between the bushings (delirn BTC bushings from PTP) and repaired it. But I can still see where it was repaired. I am so bummed. Everyone else says they can't tell, but I can.
What is everyone's most succesful method of getting rid of the excess CA before assembly?
No pics, I quit posting pics because I just get griped at about the photo quality...