Live2Dive
Member
Hey everyone. I have an issue. I have a blank I bought from a vendor on the forums here. It is the first one from this maker, and after turning it down close to my bushings, I noticed an air bubble in the casting. It looks like it was a "left over" from where the two colors were swirled together. I figured I would sand it down a bit and hopefully get it to go away. After doing so, I actually revealed another bubble. Again, I sanded down some more, only to reveal a bunch more. I went ahead and took it through 12,000 MM to see if the would be noticeable and sure enough, it has a bunch of white spots all over the blank. Is the blank toast, or can those 'dots' be filled? I'd hate to toss it, as it was a more expensive blank, but I cannot justify selling the pen. Thoughts?