USAFVET98
Member
A while back I saw on a thread, a blank that was made to look like a brick wall. Anyone know how to set type of blank up. I know how to do a checkerboard blank, but the brick is throwing me off.
That is much easier than what I am talking about, but mine looks more like a brickwall. I would HIGHLY suggest doing one like what Bruce put up first.
babyblues your way would yield 4 bricks per layer. My way yields 8.
Yes! That is what it looks like at the end of the blank. Then put a piece of veneer between the slices as you glue it up.Is this what you mean on the cuts? This would be looking at the end of the blank.
No you glue it back each time you cut.If I understand, you have to do both diagnial cuts before you glue them together.??
this is what 4 segments with a 0.1" inlay looks like.
What's the best way to cut it, a bandsaw?
I've heard the Byrnes tablesaw is even better. I don't have either though so take my free advice for what its worth:tongue:I saw the Proxxon Mini Table Saw priced around $200. Is it a lot better than using a good bandsaw?
I've heard the Byrnes tablesaw is even better. I don't have either though so take my free advice for what its worth:tongue: