dcameraman
Member
I'm working with a very unpredictable material. I've cut and drilled the material and epoxied the brass tubes into the material.
While shaping the blank I had a small section on the end of the tube chip out. About 1/8" to 3/16".
My question is this. How forgiving is the kit when it comes to brass tube length?
Can I trim the blank/tube down 3/16" or 1/4"? Will it still work in the kit?
The current kit is the Artisan Jr Gent/Statesman series.
Thanks,
Josh
While shaping the blank I had a small section on the end of the tube chip out. About 1/8" to 3/16".
My question is this. How forgiving is the kit when it comes to brass tube length?
Can I trim the blank/tube down 3/16" or 1/4"? Will it still work in the kit?
The current kit is the Artisan Jr Gent/Statesman series.
Thanks,
Josh