pegasus70
Member
I'm not exactly sure what the part is called so I will refer to it as a "designer ring". Feel free to correct me so I don;t seem so ignorant. But that isn't the question. On the Penn State Industries Designer pen kits and woodcraft European style pen kits there is a metal ring that slides over a tenon turned into the bottm end of the top half of the pen. I have been using medium thick CA to glue it in but wonder if anyone has a better idea about how to apply it or about what glue to use. I find it difficult to put in just the right amount of glue. Too much and the stuff ends up oozing out onto my oh so carefully prepared finish. Too litte and the ring falls off before too long. Any experienced pen turners have any advice?