R renowb Member Joined May 27, 2009 Messages 2,241 Mar 9, 2011 #1 I am getting ready to change out my bearings on a TurncrafterVS lathe. Just wondering if any one has any tips, tricks, comments, etc on doing this?
I am getting ready to change out my bearings on a TurncrafterVS lathe. Just wondering if any one has any tips, tricks, comments, etc on doing this?
snyiper Member Joined Aug 24, 2009 Messages 1,601 Location St Inigoes, MD Mar 9, 2011 #2 Most bearings put in the freezer before installing makes the job easier and heat gets em out!! I have never done your type lathe that is just a general rule of thumb.
Most bearings put in the freezer before installing makes the job easier and heat gets em out!! I have never done your type lathe that is just a general rule of thumb.
