DRAT
Member
Where can I find a barrel trimmer and shaft that will fit a 12.4mm tube?
Where can I find a barrel trimmer and shaft that will fit a 12.4mm tube?
Currently doing my trimming on the lathe in my chuck.
Currently doing my trimming on the lathe in my chuck.
Dan, Can you go more in depth?
I saw this thread that may be similar to what you are doing
http://www.penturners.org/forum/f30/my-new-squaring-method-94962/
Looking for ideas not involving a sander or getting more shafts/cutters
DRAT sorry to be jumping in on the thread but seems we are having the same question just different sizes needed
Dan, Can you go more in depth? I saw this thread that may be similar to what you are doing http://www.penturners.org/forum/f30/my-new-squaring-method-94962/ Looking for ideas not involving a sander or getting more shafts/cutters DRAT sorry to be jumping in on the thread but seems we are having the same question just different sizes needed
Try this. Works very good and highly effective.
http://www.penturners.org/forum/f30/trimming-lathe-no-endmill-sandpaper-117347/