Barracuda2 Lathe Key Chuck System

Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
Yes, that's what you need. I have it and it's good. Check Amazon for it, lot's of time they have it cheaper than PSI and with free shipping.
 
I bought this same 4-jaw chuck on Amazon a couple of months ago. Very happy with it so far. I use it mostly with the set of pin jaws it comes with for drilling pen blanks on the lathe. Nice thing is it comes with four sets of jaws. Others I looked at only came with one set. Comes in a storage case too.
 
Chucks

I prefer the Oneway Talon or Super Nova

easier to load items like bowls hold in one hand and tighten with the other.

Do you have a specific use for it in mind?
 
I also have the B2 chuck, it is a very nice unit. You can't go wrong for the money.

I bought both the flat jaws. The larger ones don't go small enough.
 
scotti158 said:
Does anyone have any input on this chuck? I'm thinking about buying one to do bowls and other turnings. Thanks.

http://www.pennstateind.com/mm5/merchant.mvc?Screen=PROD&Product_Code=CSC3000C

http://www.pennstateind.com/mm5/merchant.mvc?Screen=PROD&Product_Code=CJAWFJ2
Click to expand...

I bought one from Amazon, price was less than from the PSI web site and free shipping. It's a great, well made chuck and comes with several sets of jaws. I have used it to turn finials for clocks and saltshakers. Works really well.
 
You must log in or register to reply here.
Back
Top Bottom