Firefyter-emt
Member
Someone help me out here. I spend an hour or so making a dedicated sled to cut 45 degree angles in a pen blank to use on my table saw. (fancy one too, I even made adjustable length stop) I was able to cut the blank without major issues, however, I am having a heck of a time with glue up. I am trying to make a blank with the "X" on all 4 sides to give me the dual rings once turned. How the heck do you clamp this up?? Is the best bet to use a CA glue & hit it with that spray acelerator?? Just a little mad here because the blank guled up poorly with epoxy and I did not even bother to turn it. I am glad I was only using some scrap oak & maple to test the method. I think the cutting portion down good, but help me glue this up.
Any jigs you can share photos with me? [B)]
Any jigs you can share photos with me? [B)]