Attaching chrome part to chrome part

[FranM]

It's a PSI Tee Time Golf pen. The chrome part, in the center, and the golf ball were one piece that screwed into the body. The golf ball fell off of the other part and looks like it was glued into it. What would work best for reattaching? Would Epoxy hold two chromed coated parts together?
Hope the pic is ok as I am using an iPhone and had to convert from heic to jpg and resize. First rodeo with that conversion.
Thanks very much for any help.

 

[Dieseldoc]

Rough up the ball stud that fits into the cap , clean with DA and then use. J-B weld , careful as a little bit goes long way, clean any off out side cap. Let cure 24 hours and you should be good to go!!!

 

[FranM]

Rough up the ball stud that fits into the cap , clean with DA and then use. J-B weld , careful as a little bit goes long way, clean any off out side cap. Let cure 24 hours and you should be good to go!!!

Thanks. That's just what I thought about trying but didn't want to ruin it. PSI is sending a new one but am thinking that the same thing might happen and epoxying would be a better way to make sure it doesn't come apart again. The person getting it is using it for a gift for their boss so I want to make sure it is fixed permanently.

Thanks again for the help.

 

[randyrls]

Be sure to put the epoxy on the inside of the pieces. You do not want the epoxy to be "scraped" off where it can be seen.