ToddMR
Member
I have noticed on a very few kits parts I have pressed in tend to creep out over time. They include WC slim click, rinehart twist (1 of 2 have done this), guardian click. On the first 2, the top finial seems to work itself upward thus causing the clip to start turning. On the guardian clicks the bottom portion starts to loosen I assume from the constant clicking. I know the tubes are clean I just figure the constant pressure is causing the finials or bottom to start moving outward. I didn't know if most of you secure parts in using titebond or some other form of glue. It may not even be worth me worrying about as I have had so many click failures on the guardian line I am thinking about avoiding the click model altogether. But I like the WC slim click, its a nice little pen. I haven't had this issue with most other kits, and never had used any bonding agent when pressing parts in.
Any opinions on this subject would be appreciated. Of course too, it just might be how those kits react too.
Any opinions on this subject would be appreciated. Of course too, it just might be how those kits react too.