JimMc7
Member
I've just started doing a few Cigar pens and having trouble fitting tubes in reverse painted blanks. Much tighter fit than other pens I've done. I think a 10.5mm hole would work ok instead of the normal 10mm for these but asking in case others have tried this and had a bad experience!
Thanks in advance.
PS My "10.5" mm bit (used for JG-II pen barrels) is a bit undersized at 10.44mm anyway which makes it a bit closer fit.
Thanks in advance.
PS My "10.5" mm bit (used for JG-II pen barrels) is a bit undersized at 10.44mm anyway which makes it a bit closer fit.